Share this post on:

Sitive to pH changes in the range of pH 6?, indicating additional regulation factors in vivo for this enzyme in photosynthetic organisms. Type I ferrochelatases are known to be regulated by the redox state of the cell [5], their activity was found to increase in response to environmental stresses, while type II activity is repressed under these conditions [5]. The temperature optimum of FeCh activity was at 30uC, coinciding with the typical growth temperature of Synechocystis 6803. At 37uC there was still appreciable activity of the enzyme, which then declined rapidly at higher temperatures (Fig. 4). The choice of detergent appears to be important for FeCh activity. Attachment to the photosynthetic membranes is required for type II ferrochelatases in vivo in order to pursue both uptake ofProto9 and release of heme [27]. b-DM forms oblate micelles mimicking a biological membrane, while CHAPS micelles have a prolate shape [34,35]. Therefore b-DM seems to be better suited for optimal activity of FeCh compared to CHAPS. The lag phase, resulting in a sigmoidal progress curve that was Tramiprosate cost observed when measuring FeCh activity in the presence of CHAPS, could be abolished by pre-incubating the enzyme with metal ions before the start of the assay. The increased activity after the lag phase therefore was not due to a decreasing zinc pool. Enzyme kinetic plots revealed cooperativity of FeCh and FeChD347 regarding Zn2+, the substrate metal therefore might bind to peripheral sites of the enzymes [36,37]. This cooperativity was even more pronounced studying the His-tagged enzymes (HisFeCh and His-FeChD347, respectively). However, the transition in activity was observed at higher substrate concentration than expected by metal binding to the His6-tag (1-3 molecules of Zn2+ would bind directly to the His6-tag). Therefore we assume that the presence of the His-tag affected the entry of substrate into the catalytic cleft [33,37,38], as well as the membrane-association properties of the enzyme. The N-terminal Hypericin site domain of the catalytic cleft as well as the CAB-domain have been proposed to be involved in membrane binding of Synechocystis 6803 ferrochelatase in vivo [32]. Also, Zn2+ in solution can cause dimerization of Histags and therefore influence enzyme activity [39]. Removal of the His6-tag from His-FeCh or His-FeChD347, respectively, resulted in significant lower affinity for Zn2+ as judged by the higher binding constant 18325633 KM. The opposite effect was observed for Proto9. Studies on the influence of the CAB domain on the activity of the ferrochelatase of Synechocystis 6803 have been performed previously [32]. The authors showed that removal of the CAB domain including the linker region inactivates the recombinant protein [19], however, in cyanobacterial crude extracts, removal of the CAB domain only was shown to be dispensable for activity, but important for dimerization [32]. Monomeric and dimeric forms of the enzyme showed similar activities [32]. In our study, the presence of the CAB-domain affected FeCh activity mostly by lowering the KM of Proto9 and the turnover number kcat. Strikingly, kcat was much higher for FeChD347 than for the full length FeCh. These results are in agreement with data obtained from a study on a Synechocystis 6803 FeChD347 mutant, which contains more heme, but has a decreased Proto9 pool [32]. Membranes isolated from this mutant have higher ferrochelatase activity than membranes isolated from the wild type [32]. It seems that the CAB.Sitive to pH changes in the range of pH 6?, indicating additional regulation factors in vivo for this enzyme in photosynthetic organisms. Type I ferrochelatases are known to be regulated by the redox state of the cell [5], their activity was found to increase in response to environmental stresses, while type II activity is repressed under these conditions [5]. The temperature optimum of FeCh activity was at 30uC, coinciding with the typical growth temperature of Synechocystis 6803. At 37uC there was still appreciable activity of the enzyme, which then declined rapidly at higher temperatures (Fig. 4). The choice of detergent appears to be important for FeCh activity. Attachment to the photosynthetic membranes is required for type II ferrochelatases in vivo in order to pursue both uptake ofProto9 and release of heme [27]. b-DM forms oblate micelles mimicking a biological membrane, while CHAPS micelles have a prolate shape [34,35]. Therefore b-DM seems to be better suited for optimal activity of FeCh compared to CHAPS. The lag phase, resulting in a sigmoidal progress curve that was observed when measuring FeCh activity in the presence of CHAPS, could be abolished by pre-incubating the enzyme with metal ions before the start of the assay. The increased activity after the lag phase therefore was not due to a decreasing zinc pool. Enzyme kinetic plots revealed cooperativity of FeCh and FeChD347 regarding Zn2+, the substrate metal therefore might bind to peripheral sites of the enzymes [36,37]. This cooperativity was even more pronounced studying the His-tagged enzymes (HisFeCh and His-FeChD347, respectively). However, the transition in activity was observed at higher substrate concentration than expected by metal binding to the His6-tag (1-3 molecules of Zn2+ would bind directly to the His6-tag). Therefore we assume that the presence of the His-tag affected the entry of substrate into the catalytic cleft [33,37,38], as well as the membrane-association properties of the enzyme. The N-terminal domain of the catalytic cleft as well as the CAB-domain have been proposed to be involved in membrane binding of Synechocystis 6803 ferrochelatase in vivo [32]. Also, Zn2+ in solution can cause dimerization of Histags and therefore influence enzyme activity [39]. Removal of the His6-tag from His-FeCh or His-FeChD347, respectively, resulted in significant lower affinity for Zn2+ as judged by the higher binding constant 18325633 KM. The opposite effect was observed for Proto9. Studies on the influence of the CAB domain on the activity of the ferrochelatase of Synechocystis 6803 have been performed previously [32]. The authors showed that removal of the CAB domain including the linker region inactivates the recombinant protein [19], however, in cyanobacterial crude extracts, removal of the CAB domain only was shown to be dispensable for activity, but important for dimerization [32]. Monomeric and dimeric forms of the enzyme showed similar activities [32]. In our study, the presence of the CAB-domain affected FeCh activity mostly by lowering the KM of Proto9 and the turnover number kcat. Strikingly, kcat was much higher for FeChD347 than for the full length FeCh. These results are in agreement with data obtained from a study on a Synechocystis 6803 FeChD347 mutant, which contains more heme, but has a decreased Proto9 pool [32]. Membranes isolated from this mutant have higher ferrochelatase activity than membranes isolated from the wild type [32]. It seems that the CAB.

Share this post on:

Author: Cholesterol Absorption Inhibitors