Tra-precision grinding was proposed, which can It can be of of three-dimensional height significance residual materials that conform for the characteristics of three-digreat of surface for the development of your three-dimensional roughness prediction mensional roughness sampling and has additional DMPO manufacturer accurate benefits. It can be of great signifimodel for ultra-precision grinding; 2. cancenumerical worth and transform trend of Sa and Sq below distinct grindingmodel for The for the improvement from the three-dimensional roughness prediction condiultra-precision grinding; tions measured within the experiment are constant using the calculation benefits on the prediction model. The Nano-ZrO2 ceramicS and S underroughnessgrinding con2. The numerical worth and change trend of three-dimensional distinctive prediction q a ditions measured inside the experiment are constant with the calculation results in the ual components of Nano-ZrO2 ceramic in ultra-precision grinding has far better accuracy prediction model. The Nano-ZrO2 ceramic three-dimensional roughness prediction and reliability; 3. model developed by the newresults show that grindingthe height of surface reduced Simulation and experimental system for calculating with decrease feed rate, residual supplies of Nano-ZrO2 ceramic in ultra-precision grinding has greater accuracy and grinding depth, and larger grinding wheel linear speed can lower the cutting depth reliability;abrasive particle and micro-crush damage on the machined surface, plus the of single 3. Simulation and experimental final results show that grinding with reduced feed rate, decrease grinding depth, and higher grinding wheel linear speed can reduce the cutting depth of single abrasive particle and micro-crush damage from the machined surface, plus the accumulation of residual material around the machined surface is usually weakened, hence generating the height with the residual material on the machined surface descent.model developed by the new technique for calculating the height of surface resid-1.rials of Nano-ZrO2 ceramic in ultra-precision grinding was proposed, which canMicromachines 2021, 12,14 ofaccumulation of residual material on the machined surface could be weakened, as a result producing the height in the residual material around the machined surface descent.Author Contributions: Conceptualization, Z.Z.; methodology, Z.Z.; software, Z.Z.; validation, Z.Z.; formal analysis, Z.Z.; investigation, Z.Z., H.Y. and X.W.; sources, Y.Y. and J.L.; data curation, Z.Z.; writing–original draft preparation, Z.Z.; writing–review and editing, Z.Z.; visualization, Z.Z.; supervision, Z.Z.; project administration, Y.Y. and J.L.; funding acquisition, Y.Y. and J.L. All authors have read and agreed towards the published version of your manuscript. Funding: This research was sponsored by the MNITMT Purity & Documentation National Organic Science Foundation of China (51575163). Conflicts of Interest: The authors declare no conflict of interest.
Academic Editor: Mehmet Remzi Dokmeci Received: 25 October 2021 Accepted: 11 November 2021 Published: 13 NovemberPublisher’s Note: MDPI stays neutral with regard to jurisdictional claims in published maps and institutional affiliations.Copyright: 2021 by the authors. Licensee MDPI, Basel, Switzerland. This short article is an open access report distributed below the terms and conditions with the Creative Commons Attribution (CC BY) license (https:// creativecommons.org/licenses/by/ four.0/).Soft lithography is definitely the most common strategy for rapid and low-cost fabrication of microfluidic devices for medicine, biology, and c.
